Account confirmation is required. Please, check your email for the confirmation link.
First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!
USBGear offers TTL adapters to provide connectivity between your USB and serial UART interfaces. USB TTL adapters vary in voltage and can be monitored with LED indicators. The USB to TTL interface supports the full range rs232 serial UART signals. USBGear has what you need for your communication to RS232 applications.
The 5 foot Serial UART USB to 3.3v TTL PIN Header Cable (TTL level) adapter allows you to connect your computer through the USB port and use it as a regular serial communication device with support for 7 or 8 data bits.
The USB to serial UART TTL adapter is auto sensing and is supported in Windows 10 or earlier OS and Mac OS and Linux. The serial UART adapter electronics automatically sense the voltage for its operation. Transmit and receive LED lights are embedded into the translucent USB molded jacket.
USB to RS232 TTL voltage settings just got easier! Up until now you've had to make a choice between USB to TTL adapters and their voltage with either or selections. This USB to RS232 TTL/CMOS adapter cable eliminates that by allowing you to choose a voltage setting.
Up until now you've had to make a choice between USB to TTL adapters and their voltage with either or selections. This USB to RS232 isolated TTL/CMOS adapter cable eliminates that by allowing you to choose a voltage setting right at the adapter's connection point at the terminal block.
USB TTL adapter with integrated USB type-A port incorporates a 6-wire terminal block and individual wires with TTL header pin connectors to connect as you see fit. The voltage of 5V or 3.3V is set by jumper settings on the circuit board anf supports RS232 signals GND, CTS#, RTS#, TxD, RxD, and VCC with LED indicators for power, TxD, and RxD.